Grain-systems PNEG-1283 Manuel d'utilisateur télécharger pdf (Page 20)

6. Assembly Instructions

20 PNEG-1283 Moisture Sampler

Moisture Sampler Update Kit (D04-0532) Assembly Instructions

To replace parts used on the D01-1945-8 Moisture Sampler assembly - Sold from 1/1/07 to 7/1/09

1. Begin by removing the belt guard, belt, Moisture Sampler lid, end plates, bearings, sampler auger,

and sheave, along with any associated hardware.

2. Assemble the bearings (D03-0845) to the end plates (D01-1871 and D01-2338) with the 1/4" bolts,

lock washers and nuts.

3. Mount the three (3) hole end plate (D01-1871) to the bottom of the Moisture Sampler body with the

1/4" bolts, lock washers, and nuts.

4. Insert the sampling auger (D04-0530) into the bearing on the three (3) hole end plate.

5. Insert the shaft at the top of the auger into the bearing on the two (2) hole plate (D01-2338) and

mount the plate to the Moisture Sampler body. Ensure that the slot in the two (2) hole plate is

closest to the discharge box.

6. Insert the shaft at the top of the auger into the split taper bushing (FH-5536) and place the square

key in the slot for both parts. Attach the sheave (017-1451-8) to the bushing with the bushing bolts.

Tightening these bolts will position the bushing and sheave on the auger shaft. Position such that

the sheave center is aligned with the unload auger pulley.

7. The belt is installed on the unload auger pulley and rolled onto the sheave. This belt can be

tensioned by tightening the bolt in the slot on the two (2) hole plate in the desired position. Ensure

that the belt is stretched tight.

8. Latch the lid (D01-2337) onto the Moisture Sampler body.

9. Drill two (2) 3/8" holes at a position 1" below the bottom guard holes in the discharge box. Assemble

the belt guard (D01-1888) to the discharge box using the current top holes and the newly drilled

bottom holes.

1 2 ... 15 16 17 18 19 20 21 22

Pas de commentaire

Grain-systems PNEG-1283 Manuel d'utilisateur Page 20