Grain-systems PNEG-1283 Manuel d'utilisateur télécharger pdf (Page 12)

4. Installation

12 PNEG-1283 Moisture Sampler

19. To install the Moisture Sampler drive belt, loop the belt over one of the sheaves and the stretch it

over the other one. Belt direction is marked with an arrow on belt. If necessary remove any belt

links. After the belt is installed the sheave on the auger shaft can be adjusted forward or back for

proper belt alignment. The slot in the end plate can be used to tension the belt. When everything is

aligned tighten the auger shaft sheave and any other hardware left loose.

Figure 4I

20. Install the belt guard using four (4) 3/8" bolts (S-7927) and nuts (S-968).

Figure 4J

Bolt locations for belt guard

4 ea. 3/8"-16 x 1" bolt (S-7927)

4 ea. 3/8"-16 nut (S-968)

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 21 22

Pas de commentaire

Grain-systems PNEG-1283 Manuel d'utilisateur Page 12