Grain-systems PNEG-1283 Manuel d'utilisateur télécharger pdf (Page 9)

4. Installation

PNEG-1283 Moisture Sampler 9

10. Now put the Moisture Sampler assembly up to the discharge box again and put in the 5/16" bolts

and nuts and tighten just enough to firmly hold Moisture Sampler in place. Use a marker and mark

the four (4) holes at the sensor end of the assembly as shown in Figure 4E. Also mark the square

hole inside the sample tube as shown in Figure 4E.

Figure 4E

11. Remove the Moisture Sampler again and drill the four (4) bolt holes at the sensor end with a 3/8"

drill bit and cut out the square hole marked out in Step 10.

Mark and drill holes with a

5/16" drill bit

Mark and cut square hole

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 21 22

Pas de commentaire

Grain-systems PNEG-1283 Manuel d'utilisateur Page 9