Grain-systems PNEG-1283 Manuel d'utilisateur télécharger pdf (Page 7)

PNEG-1283 Moisture Sampler 7

4. Installation

Installation Instructions for Dryers Made before September 2002

Figure 4A

1. Remove the auger bearing shield. (See Figure 4A.)

2. Remove the lock collar from the auger shaft. (See Figure 4B.) To remove the lock collar loosen the

set screw and then locate the dimpled hole on the side of the lock collar. Using a hammer and

punch, set the punch in the dimpled hole and hit it in a clockwise direction until the lock collar is

freed from the bearing.

Figure 4B

Auger tube

Auger bearing shield

Discharge switch conduit

Unload auger bearing plate

Standard grain sampler

Discharge side panel

Discharge box bearing plate

Lock collar

Set screw

1 2 3 4 5 6 7 8 9 10 11 12 ... 21 22

Pas de commentaire

Grain-systems PNEG-1283 Manuel d'utilisateur Page 7